Mounting Precautions (For Sharp Dealers And Service Engineers) - Sharp PN-80TH5 Operation Manual

Hide thumbs Also See for PN-80TH5:

Table of Contents

(For SHARP dealers and service engineers)

• When installing, removing or moving the monitor, ensure that this is carried out by at least 4 people.

• Be sure to use a wall-mount bracket designed or designated for mounting the monitor.

• This monitor is designed to be installed on a concrete wall or pillar. Reinforced work might be necessary for some materials

such as plaster / thin plastic board / wood before starting installation.

This monitor and bracket must be installed on a wall which can endure at least 4 times or more the weight of the monitor.

Install by the most suitable method for the material and the structure.

• To attach a VESA-compliant mounting bracket, use M6 screws that are 5/16 inch (8 mm) to 3/8 inch (10 mm) longer than the

thickness of the mounting bracket.

• Do not use an impact driver.

• After mounting, please carefully ensure the monitor is secure, and not able to come loose from the wall or mount.

• Do not use any screw holes other than VESA holes for installation.

• When moving this monitor, be sure to hold it with the handles, the unit sides, the unit bottom or the unit top. Do not grasp the

screen, unit corner, tray, speaker, or speaker cover. This may cause product damage, failure, or injury.

• If you need to temporarily place the monitor on a table or other surface during installation, spread a thick soft cloth on the

table to prevent damage to the screen and table.

• Prior to repacking or removal, remove the tray and speaker covers.

• This monitor should not be mounted flat or used as a touch table type installation. Please consult an authorized SHARP

dealer before considering any type of flat installation (when the monitor is tilted more than 20 degrees upward from the

perpendicular in relation to a level surface), and find out about the mandatory flat mounting instructions.

nAttaching the Tray

Tray mount fitting

Caution

• When attaching the tray, do not pinch the USB cable on the back

of the tray.

The USB cable on the back of the tray can be fastened with the cable clamp to the rear of the monitor.

Mounting Precautions

5/16 - 3/8 inch (8-10 mm)

Push until the tabs lock

into place (4 places)

*2 *2

Screws (M6)

Mounting bracket

Monitor mounting

Tabs (4 places)

Table of Contents