Modena Veloce Series User Manual Book page 6

2. Remove the pressing plate of
the power cord and keep the
screws.
3. Gash the middle of the outer
jacket with a sharp knife in
order to insert the power
cord (lines).
NOTE
The installation of every ends of neutral line (blue), live line (brown
/red) and earth line (green/yellow) should be corresponding to the
other end on wiring terminals
.
5
Tighten the wire-pressing plate
with the screws to the primary
position. Make sure that the
power cord doesn't come loose
when it is pulled at 60N
6. Connect the end of the power
cord to wiring terminals; the
method is as shown in the
image.
6
force.