BORETTI CFBG902AN Instruction On Mounting And Use Manual page 230

CONNECTING THE FEEDER CONNECTING THE FEEDER CABLE
CABLE
WARNING: If the power supply cable is
damaged, it must be replaced only by
To connect the feeder cable to the cook-
an authorised service agent in order to
er it is necessary to:
avoid a hazard.
– Remove the two screws that hold
To connect the feeder cable to the cooker
shield A behind the cooker.
it is necessary to:
– Open completely the cable clamp D.
• Remove the two screws that hold
– Position the U bolts onto terminal block
shield "A" behind the cooker.
B (fig. 10.1) according to the diagram
• Open completely the cable clamp "D".
in fig. 10.2a, 10.2b, 10.2c.
• Position the U bolts onto terminal
– Insert the feeder cable into the cable
block "B" (fig. 10.1) according to the
clamp D. The supply cable must be
diagram in figs. 10.2a, 10.2b, 10.2c.
of a suitable size (see the section
"Feeder cable section").
• Insert the feeder cable into the cable
clamp "D". The supply cable must
– Connect the phase and earth cables
be of a suitable size (see the section
to terminal B according figures 10.2a,
"Feeder cable section").
10.2b, 10.2c.
• Connect the phase and earth cables
– Pull the feeder cable and block it with
to terminal "B" according figures
the cable clamp D.
10.2a, 10.2b, 10.2c.
– Re-mount shield A.
• Pull the feeder cable and block it with
the cable clamp "D".
N.B. The earth conductor must be left
about 3 cm longer than the others.
• Re-mount shield "A".
N.B. The earth conductor must be left
about 3 cm longer than the others.
230 V~
230 V ac
1 2 3 4
L
1
1 2 3 4
N(L
L1
Fig. 10.2a
230
5
N PE
(L )
2
5
)
2
PE
Fig. 10.2b
Fig. 10.1
FEEDER CABLE SECTION
Type "H05RR-F"
230 V ac
400 V 2N ac
400 V 2N ac
(*) – Connection with wall box connection
400 V 2N~
400 V 2N ac
5
1 2 3 4
L L N N PE
1 2 1 2
1 2 3 4 5
L2 N1 N2
L1
PE
D
3 x 2,5 mm
5 x 1,5 mm
4 x 1,5 mm
400 V 2N~
400 V 2N ac
1 2 3
L L
1
1 2 3
L2
L1
Fig. 10.2c
B
A
2 (*)
2
(*)
2 (*)
5
4
N PE
2
4 5
N
PE