BORETTI CFBG902AN Instruction On Mounting And Use Manual page 185

LIGHTING GAS BURNERS FITTED
WITH SAFETY VALVE DEVICE
(Auxiliary, Semi-rapid and Rapid burners)
In order to light the burner, you must:
1. Push and turn the knob in an
anticlockwise direction up to the
position (maximum rate), push in and
hold the knob until the flame has been
lit (fig. 3.2).


The sparks produced by the lighter
situated inside the relative burner will
light the flame.


In the event that the local gas supply
conditions makes it difficult to light the
burner in
the knob in


If there is no main electrical supply,
bring a lighted match close to the
burner.
2. Wait for about ten seconds after the
gas burner has been lit before letting
go the knob (safety device activation
delay).
3. Adjust the gas valve to the desired
position.
If the burner flame should go out for some
reason, the safety valve will automatically
stop the gas flow.
To re-light the burner, return the knob to
the closed position, wait for at least
1 minute and then repeat the lighting
procedure.
N.B. When the cooker is not being
used, set the gas knobs to their closed
positions and also close the cock
valve on the gas bottle or the main gas
supply line.
position, try again with
position.
Caution!
Do not cover the hob with aluminium
foils.
Caution!
The cooking hob becomes very hot
during operation.
Keep children well out of reach.
Fig. 3.1
Fig. 3.2
185