BORETTI CFBG902AN Instruction On Mounting And Use Manual page 208

TELESCOPIC SLIDING SHELF SUPPORTS
The telescopic sliding shelf support makes it safer and easier to insert and remove the
oven shelf.
It stops when it is pulled out to the maximum position.
Important! When installing the sliding shelf support, make sure that:
You fit the RH and LH sliding guides on the wire support (fig. 7.9).
•
You press the RH and LH sliding guides against the fixing wires (fig. 7.10). You will
•
hear a click as the safety locks clip over the wire.
You fit the oven shelf above the sliding shelf support (figs. 7.11, 7.8).
•
• You slide, on the guides inside the oven cavity, the sliding shelf support with the oven
shelf fitted above:
– the oven shelf shall run out towards the oven door;
– do not use the top shelf position;
– the short bend on the wire support shall face the inside of the oven;
the oven shelf must be fitted so that the guard rail faces the inside of the oven.
–
To remove the RH and LH sliding guides from the wire support:
Find the safety locks. These are the tabs that clip over the fixing wire (arrow 1 in fig. 7.13).
•
Pull the safety locks away from the fixing wire to release the sliding guide (arrow 2 in fig. 7.13).
•
Cleaning the sliding shelf supports:
• Wipe the supports with a damp cloth and a mild detergent only.
• Do not wash them in the dishwasher, immerse them in soapy water, or use oven
cleaner on them.
Fig. 7.8
LH sliding guide
Long bend
Fig. 7.11
Fig. 7.12
208
RH sliding guide
Short bend
Fixing wires
Wire support
Guard rail
(fig. 7.8)
Fig. 7.9
Fig. 7.10
Fig. 7.13
2
2
1