Table of Contents
Advertisement
8. Slide both lock pillar brackets down and forward
from the receiver brackets. You may need to lift the
hardtop slightly to remove the brackets.
9. Disconnect both wire connectors located behind the
lock pillar brackets. These are the rear window
defogger wires.
10. With one person on each side, gently lift the hardtop
approximately 8 inches (200 mm) straight up.
Remove the hardtop over the rear of the vehicle.
11. Install the HATCH (45) fuse to enable the storage
compartment lid release button and center console
release switch. You will need the fuse installed if
you have to raise your convertible top.
The fuse that enables these releases is not installed
at the assembly plant and should be in your center
console. See "Instrument Panel Fuse Block" in the
Index for location of the fuse when installing it.
I
2-98
Advertisement
Table of Contents
