To Check And Add Hydraulic Clutch Fluid - Chevrolet 1995 Corvette Owner's Manual

How To Check and Add Fluid
(LT1 Engine Only)
You must loosen and remove the two screws before the
PCM unit will lift out.
The clutch master cylinder is under the Powertrain
Fluid should be added if the fluid level is at or below the
Control Module (PCM) in the left rear area of the engine
ADD mark on the reservoir. There are additional
instructions on the reservoir cap.
compartment.
To check the fluid, look at the area between the PCM
and the battery.
To add fluid, remove the PCM unit.
When returning the PCM to its proper position, make
sure the unit is fully rearward in the bracket prior to
installing the two screws.
How to Check and Add Fluid
(LT5 Engine Only)
The clutch master cylinder is under the Engine Control
Module (ECM) in the left rear area of the engine
compartment.
To check the fluid, look at the area
and the battery.
To add fluid, remove the ECM unit
between the ECM
6-25