Table of Contents
Advertisement
4. Fill with the proper mix. Add coolant until you see a
steady stream of coolant coming from the bleed
valve.
5 . Close the bleed valve.
6. Continue to fill the coolant high fill reservoir up to
the base of the filler neck.
7. Rinse or wipe the spilled coolant from the engine
and compartment.
8. Start the engine and allow it to run in idle for
approximately four minutes. By this time, the
coolant level inside the coolant high fill reservoir
will be lower. Add more of the proper mix through
the filler neck until the level reaches the base of the
filler neck.
9. Shut the engine off and replace the pressure cap. Be
sure the arrows on the cap line up like this.
5-25
Advertisement
Table of Contents
