1 Introduction
This document describes the process to configure the INGECON SUN STORAGE 1Play (TL and TL M
version) to work with PYLONTECH FORCE H1/H2 and POWERCUBE X1/X2 batteries.
The PYLONTECH HV and ISS 1Play equipment can be used in the following type of single-phase
installations:
•
Stand-alone installations
•
UPS installations
•
Self-consumption installations
The minimum FW versions to work with the ISS 1Play and PYLONTECH HV are the following:
Minimum Firmware Version used in the PYLONTEHC HV:
•
Force H1/H2 → V1.3 or higher
•
Powercube X1/X2 → V4.6 or higher
The battery´s firmware is supplied by the qualified distributor of Pylontech. For further details, check the
"Installation Manual of Pylontech".
Minimum Firmware Version used in the ISS 1Play TL:
•
Inverter: ABH1002AA or higher
•
Display: ABH1003_Q or higher
Minimum Firmware Version used in the ISS 1Play TL M:
•
Inverter: ABH1007_ or higher
For further details, check the "List of approved lithium batteries" available on Ingeteam website.
Technical Guide
19/11/2020
INGECON SUN STORAGE 1Play
3/11