Mounting The Actuator On The Valve After Service Or Conversion Work - Samson 3251-E Mounting And Operating Instructions

Servicing and conversion
9.3 Mounting the actuator on
the valve after service or
conversion work
1. Mount actuator. See associated actuator
documentation and the 'Installation' sec-
tion.
2. Adjust lower or upper signal bench
range. See associated actuator docu-
mentation.
3. If the valve has been removed, re-install
the valve into the pipeline (see the 'Instal-
lation' section).
4. Put the control valve back into operation
(see the 'Start-up' section). Observe the
requirements and conditions for start-up
or putting the valve back into operation.
9-6 EB 8052-E EN