Tyco Electronics PRO-CRIMPER III Instruction Sheet

PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended-use, production operations is available.
The PRO-CRIMPER III Hand Tool is a Commercial" grade tool and is
designed primarily for field installation, repair, maintenance work, or
prototyping in industrial, commercial, or institutional applications. Product
crimped with this tool will meet the crimp height requirement for hand tools in
the appropriate 114 application specification, but may not comply with other
feature parameters of the specification. Tyco Electronics offers a variety of
tools to satisfy your performance requirements. For additional information,
contact the Tooling Assistance Center at 1-800-722-1111.
DIE ASSEMBLY
PART NUMBER
224928-2
}
Contact the Tooling Assistance Center
(see below) for specific connector part numbers.
1. INTRODUCTION
PRO–CRIMPER III Hand Tool Assembly 224928–1
consists of Die Assembly 224928–2 and
PRO–CRIMPER III Hand Tool Frame 354940–1. The
die assembly consists of two crimping dies. Read
these instructions thoroughly before crimping any
connectors.
Dimensions on this sheet are in millimeters [with
NOTE
inch equivalents provided in brackets]. Figures
i
and illustrations are for identification only and are
not drawn to scale.
E
2008 Tyco Electronics Corporation, Harrisburg, PA
All International Rights Reserved
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
PRO-CRIMPER* III Hand
Tool Assembly 224928-1
with Die Assembly 224928-2
Die Assembly
224928-2
Moving Jaw
Ratchet
Adjustment Wheel
}
CONNECTOR
FAMILY
Modular Plug Connectors
(External Strain Relief Application)
Figure 1
TOOLING ASSISTANCE CENTER 1-800-722-1111
PRODUCT INFORMATION 1-800-522-6752
Stationary
Jaw
TYPE
Stranded or Solid,
Unshielded or Shielded Round Jacket
Reason for revision is provided in Section 9,
REVISION SUMMARY.
2. DESCRIPTION
(Figures 1 and 2)
The tool features a tool frame with a stationary jaw
and handle, a moving jaw, a moving handle, and an
adjustable ratchet that ensures external strain relief
crimping. The tool frame holds a die assembly with a
seating chamber and two crimping chambers.
The die assembly features an indenter die and an
anvil die.
Die retaining pins and die retaining screws are used
to position and secure the dies in the tool frame.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
Instruction Sheet
408-4167
24 JAN 08 Rev A
Back of Tool
Pivot
Pin
PRO-CRIMPER III
Hand Tool Frame
354940-1
Stationary
Handle
Moving
Handle
CABLE
INSUL DIA
(mm [in.])
4.70-5.46
[.185-.215]
1 of 4
LOC B