Backup And Restore The Fixture Configuration; Clean The Lens - ETC Desire Fresnel User Manual

Update All Connected Fixtures
1. After you update the firmware on a fixture, verify that the fixture is not receiving
DMX/RDM before you proceed.
2. Press the Menu button (
through the menu: Local Settings > Push Firmware.
3. When the screen prompts you to confirm, press the green encoder (for the OK icon
continue. The updated firmware is copied to all connected fixtures, and the screens on
connected fixtures display a progress message ("Firmware RX x %").

Backup and Restore the Fixture Configuration

You can save the fixture settings to a USB flash drive and then apply those settings to another
fixture. You can also use the saved settings as a backup, and then apply the settings to the same
fixture to restore it to a previous state.
Back Up Fixture Settings
1. Insert the USB flash drive in the USB port on the rear of the fixture (see
page 6 ).
2. Press the Menu button (
menu: Local Settings > USB > Save All Settings.
3. The display shows the file name to be saved (for example, decfg00.xml). Press the green
encoder (for the Save icon
The display returns to the USB screen when the process is complete.
4. Remove the USB flash drive from the USB port.
Apply (or Restore) Fixture Settings
1. Insert the USB flash drive that contains the fixture settings file (decfg xx .xml) in the
USB port on the rear of the fixture (see
2. Press the Menu button (
menu: Local Settings > USB > Apply All Settings.
3. When the screen prompts you to select the fixture settings file, use the Intensity encoder
to navigate to the correct file and select it.
The display returns to the USB screen when the process is complete.
4. Remove the USB flash drive from the USB port.
Push Fixture Settings to All Connected Fixtures
1. Press the Menu button (
menu: Local Settings > Push Settings.
2. When the screen prompts you to confirm, press the green encoder (for the OK icon
continue. The settings are copied to all connected fixtures, and the screens on connected
fixtures display a confirmation message ("Config Received").

Clean the Lens

Clean the lens using a clean, micro-fiber cloth. You can use isopropyl alcohol on the cloth, but
do not spray the cleaning solution directly onto the lens or into the interior of the fixture.
24
) on the fixture, and then use the Intensity encoder to navigate
), and then use the Intensity encoder to navigate through the
) to save the file to the USB flash drive.
User Interface on page 6
), and then use the Intensity encoder to navigate through the
), and then use the Intensity encoder to navigate through the
User Interface on
).
Desire Fresnel User Manual
) to
) to