Operating Mode/Status Description - Vertiv Liebert GXT-MT+10KVA User Manual


26: L1 output voltage calibration
Interface

27: L2 output voltage calibration
Interface

28: L3 output voltage calibration
Interface

3-8. Operating Mode/Status Description

Following table shows LCD display for operating modes and status.
Operating Description
mode/status
UPS Power On When UPS is powered on, it will enter into this mode
for a few seconds for initializing the CPU and system.
Setting
Parameter 2:
It shows the internal measurement value of the output voltage,
and you can calibrate it by pressing Up or Down according to the
measurement from an external voltage meter. The calibration
result will be effective by pressing Enter. The calibration range is
limited within +/-9V. This function is normally used for parallel
operation.
Setting
Parameter 2:
It shows the internal measurement value of the output voltage,
and you can calibrate it by pressing Up or Down according to the
measurement from an external voltage meter. The calibration
result will be effective by pressing Enter. The calibration range is
limited within +/-9V. This function is normally used for parallel
operation.
Setting
Parameter 2:
It shows the internal measurement value of the output voltage,
and you can calibrate it by pressing Up or Down according to the
measurement from an external voltage meter. The calibration
result will be effective by pressing Enter. The calibration range is
limited within +/-9V. This function is normally used for parallel
operation.
26
LCD display