Humidity/Temp. Measurement - Lutron Electronics EM-9300SD Operation Manual

4-3 Humidity and Temperature measurement
1) Function select to " Humidity/Temp. " measurement.
Plug the " Probe Plug " ( 3-21, Fig. 1 ) into the " Probe
Input Socket " ( 3-7, Fig. 1 ).
2) Power on the meter by pressing the " Power Button "
( 3-2, Fig. 1 ), the LCD shows the unit " %RH " & "
or " at the same time and measured value will
℃ ℉
show on the display ( upper display is Humidity
value, the lower display is the temperature value ) .
Change the temperature unit (
The meter Temp. display unit is defaulted to "
If intend to let the meter's temperature unit default
to " " , then please refer chapter 7-6 ( page 22 ).
℉
4-4 Type K/J thermometer
1) Function select to " Type K/J thermometer "
2) Plug the Thermocouple Temp. Probe ( Type K Temp.
probe pr Type J Temp. probe, optional ) into " Type
K/J Probe Input Socket " ( 3-8, Fig. 1 )
The Display will show the measuring value that
sensing from the Temp. probe.
3) If the Display show the indicator " K ", it is ready
for Type K thermometer.
If the Display show the indicator " J ", it is ready
for Type J thermometer.
Change the K type or the J type
The meter is defaulted to " Type K thermometer ".
If intend to select the " Type J thermometer with
default , please refer chapter 7-5 ( page 21 ).
℃ ℉
9
, )
".
℃