Ricoh D182 Service Training page 94

Exit Guide Plate Open/Close
 For no stapling, no shift tray side-to-side motion:
 The exit guide plate stays down
 Shift tray side-to-side motion
 When the shift motor starts, the exit guide plate motor lifts the exit
guide plate. When shift has finished, the exit guide plate drops
again.
 Stapling: The motor the exit guide plate up at the start of the job
and drops it at the end of the job.
» Necessary to make sufficient space between the exit rollers for long
» The exit guide plate HP sensor detects the correct time to stop moving
Slide 94
 This is basically the same as the B793 finisher.
 The guide plate moves away from the paper path. Because of this, the leading
edge of copies in the jogger unit does not hit the exit rollers, and is not aligned
incorrectly before stapling.
 This is done for all paper sizes, but it is only necessary for long paper sizes.
paper (for example, A3/DLT)
down.
94
OR-C2 Training
Motor
HP
Sensor