Ricoh D182 Service Training page 30

Capturing the Debug Logs - 2
 Insert the SD card into the slot on the side of the operation panel.
 Set the start date of the log with SP5-857-101
 e.g.: March 28, 2013: input 20130328 (yyyymmdd)
 Set the date three days earlier than the occurrence of the
problems.
 Set the end date of the log with SP5-857-102
 e.g.: March 30, 2013: input 20130330 (yyyymmdd)
 Execute SP5-857-103 to write the debug log to the SD card.
 The approximate time it takes to transfer the debug log is as
follows. Transfer time may be affected by the type or format of the
SD card.
» Controller debug log (GW debug log): 2 - 20 minutes
» Engine debug log: 2 minutes
» Operation panel debug log: 2 - 20 minutes
Slide 30
 See the 'Retreiving the Debug Logs' section in the service manual for details of
the procedures.
30
OR-C2 Training