The machine is the same as the OR-C1, except for the
following points:
Scanner: This is the same as the MET-C1.
SBU board: This is also the same as the MET-C1.
Operation panel: This has been increased from 8.5 inches
Boards: A GW+ controller is used. The BCU and IPU have
Main switch: This is the same type as CH-C1 and MET-C1.
The metal frame was modified because of the changes to
Slide 7
No additional notes
Changes to the Engine
to 9 inches. This is also the same as the MET-C1.
been changed.
This means that the method of turning power off before
removing machine components is different from OR-C1.
the scanner, controller board, and main PCBs.
7
OR-C2 Training