PACSystems™ Industrial Displays User Manual
GFK-3138B
3.3
RXi - Web Panel
3.3.1
Jumpers and Connectors Locations
Setting Jumper Functions
Before installing the Web Panel, please set the necessary functions following the chart below.
Note: To determine Pin 1 of the jumper and port, please observe the marking beside the plug. it will be
marked as "1", a bolded line, or a "△"; see the welding plate at the backside, the square welding plate is
Pin 1.
Setting Jumper Functions (SW1)
SW1: 2bit switching ON/OFF, used to set the recording and the starting mode of the Motherboard.
SW1
Figure 69: Junction Function (SW1)
Hardware
DOWNLOAD
1.BOOT_MODE1_S
2.BOOT_DEV
ON
OFF
NORMAL
MODE
MODE
SD
DEFAULT
Section 3
Jul 2021
83