Resetting Alarms And Faults - Xtralis VESDA Sensepoint XCL Installation Manual

VESDA
After replacing the sensor, press and hold the UP button for 2 seconds to activate warm-up mode. In this
mode, the output continues to be held in its inhibit state.
To switch to normal monitoring mode press and hold the DOWN button for 5 seconds.
4.7

Resetting Alarms and Faults

When there is latched gas alarm or faults, reset them by pressing the UP or DOWN button shortly. This will
reset latched alarms and faults and initiate a self diagnostics to make sure there is no warning or fault in the
detector.
35563_02
VESDA Sensepoint XCL – Large Bore Installation Manual
UP DOWN
29