Securing The Back Box To A Wall - Xtralis VESDA Sensepoint XCL Installation Manual

VESDA
2.7

Securing the Back Box to a Wall

CAUTION:
Before starting installation, make sure that the system controller or external power source is switched
off.
1. There are four screw positions in the rear of the back box for mounting purposes. Punch the required
screw positions or drill using a 4 mm drill.
2. Secure the back box in its mounting position with suitable fixings appropriate to the mounting surface. Do
not over-tighten.
3. There are four cable entry knock-outs on three sides of and on the rear face of the back box. Drill or punch
the entries as required.
35563_02
VESDA Sensepoint XCL – Large Bore Installation Manual
13