2.10 Securing The Detector Module And Flow Cap - Xtralis VESDA Sensepoint XCL Installation Manual

VESDA Sensepoint XCL – Large Bore Installation Manual

2.10 Securing the Detector Module and Flow Cap

1. Position the detector module with Flow Cap onto the back box ensuring that the status indicator is in the
top left-hand corner when viewed from the front. Tighten the four retaining screws using a No. 2 Phillips
screwdriver to secure.
CAUTION:
Do not over-tighten the screws. If required, the current sink/source selection switch can be set at this
point.
2. Where used, tighten the sealing nut of the cable gland to secure the cable.
16
VESDA
www.xtralis.com