Cable Connections - Xtralis VESDA Sensepoint XCL Installation Manual

VESDA Sensepoint XCL – Large Bore Installation Manual
2.8

Cable Connections

1. Fit suitable cable glands appropriate to the application and type of cable being utilized to the opened
cable entries.
2. Feed the cable through the cable gland.
3. Turn over the detector module and locate the terminal blocks on the back. Remove the terminal blocks by
pulling them toward the center of the module.
4. Connect the cable to the appropriate terminal block, referring to the relevant wiring diagram. Strip and
insert the end of each wire into the corresponding terminal hole. Using a flat-blade terminal screwdriver,
tighten the terminal screw until the wire is secured. Use a ferrule on the wire where necessary.
CAUTION:
Do not over-tighten the terminal screw.
14
VESDA
www.xtralis.com