Restarting Radio Control Signal Reception; Light; 12/24 Hour Time Format; Temperature - Auriol 4-LD5370 Usage And Safety Instructions

Restarting radio control signal reception

Radio control signal reception can be restarted by pressing and holding the MEM- -
button 17 for 3 seconds. The radio control symbol 10 will blink on the display. The
radio-controlled weather station will now start the DCF77 signal reception attempt. This
process can take from 3-10 minutes.

Light

Press the SNOOZE/LIGHT button 7 to briefly activate the backlight.

12/24 hour time format

Press and hold the °C/°F-SET-button 18 1x long and 3 x briefly in normal time display
mode. The 12- or 24-hour time format will blink and can be set by pressing the MEM-
-button 17 or the CH- -button 16. In 12-hour mode the display will show AM before
noon and PM after noon.

Temperature

Press the °C/°F-SET-button 18 to show the temperature unit degrees Celsius (°C) or
degrees Fahrenheit (°F).
Indoor / outdoor temperature

Speed setting

Press and hold the MEM- -button 17 and the CH- -button 16 to use the speed
setting feature when setting numerical values.

Basic settings

The following basic settings are possible: Hours, minutes, time zone and 12/24 hour
time format. Press and hold the °C/°F-SET-button 18 in normal time display mode for 3
seconds. The hours will blink and can be set by pressing the MEM- -button 17 or the
-button 16. Press the °C/°F-SET-button 18 to confirm your setting. Set the
CH-
minutes, time zone 00-(-) and 12/24 hour time format in the same way.

Setting the alarm time

Press the ON/OFF-ALARM-button 19 1x briefly while in normal time display mode to
enter alarm mode. OFF and AL will appear on the display. Press and hold the ON/OFF-
ALARM-button 19. The hours will blink and can be set by pressing the MEM- -button
17 or the CH- -button 16. Press the ON/OFF-ALARM-button 19 to confirm your
setting. The minutes will blink and can be set in the same way. Press the ON/OFF-
ALARM-button 19 to confirm your setting and return to normal time display mode.

Activating and deactivating the alarm

Press the ON/OFF-ALARM-button 19 1x briefly in normal time display mode to enter
alarm mode. OFF and AL will appear on the display.
Press the MEM- -button 17 or the CH- -button 16. The set alarm time and the alarm
symbol 5 will appear on the display. The alarm is now activated. Press the MEM- -
button 17 or the CH- -button 16 again. OFF will appear on the display and the alarm
symbol 5 will disappear. The alarm is now deactivated.
Press the ON/OFF-ALARM-button 19 2 x briefly to return to normal time display mode.

Snooze (SNOOZE)

Press the SNOOZE/LIGHT-button 7 when the alarm sounds to temporarily deactivate
the alarm. Z will blink on the display. After 5 minutes, the alarm will sound once again.
Z
Press any button other than the SNOOZE/LIGHT-button 7 to turn the alarm off.
- 43 -