Table of Contents
Advertisement
INSTALLATION
BLEED OFF
See previous heading "Overflow and Bleed-Off feature" under
"Water Installation".
Adjusting the bleed rate is necessary to reduce the salt deposit
on the pads. Salt deposit can NEVER be entirely eliminated,
only the rate of deposit can be changed. The bleed feature
causes some salt concentrated water in the tank (reservoir) to
be drained away. Fresh water enters the cooler automatically as
the salty water exits.
The rate of bleed will vary according to water quality, but should
be set to a minimum rate as set out below:-
EXT155 (small cabinet): 0.08 gpm
EXT265 (large cabinet): 0.13 gpm
NOTE! Bleed adjustment cannot be precise as operating
conditions vary continually.
NOTE! Previous warning about running coolers without bleed-
off.
FILTER PAD
WATER BLEED
OVERFLOW
APONES
BLEED FUNNEL
(Remove to drain)
"O" RING
BUSH
"O" RING
TANQUE
TANK NUT
DRAIN ADAPTOR
DRAIN NUT
LL579-E
PLUGS
TANK
ILL579-E
ILL579-E
INSTALL AND OPERATION MANUAL EXT
|
13
Advertisement
Table of Contents
