Table of Contents
Advertisement
INSTALLATION
SECURING THE LEG SUPPORTS
The telescopic leg supports (with feet attached) slide up and
down inside the four corner posts. By removing the screw from
the lower end of the corner post you enable the leg support to
slide down to roof level.
Make sure each leg is vertical before securing. Secure foot to
roof with 2 screws (minimum).
Maintain downward pressure on corner post as you replace the
screw to ensure that the bottom of the corner post is sitting flush
with base of corner support (view through "V" notch). Ensure
screw is horizontal when replaced.
The support legs are not full weight bearing and are only
intended for additional support in case of high winds, etc.
|
6
WEATHERSEAL AND LATCH
(Model dependant, refer to Dealer.)
Where fitted, the Weatherseal latch performs two functions.
In the locked position it acts as a latch, preventing movement
during transport.
LOCKED POSITION
OPERATING POSITION
In the operating position it acts as a restrainer, preventing gusts
ILL958-A
of wind from opening the Weatherseal. Once the cooler is
installed on the roof, squeeze the latch and rotate it clockwise to
its operating position.
ILL958-A
Check the Weatherseal moves freely and without obstruction by
lifting the latch and rotating counterweighted arm.
ILL959-B
ILL959-B
ILL960-A
ILL1649-A
ILL1650-A
ILL525-D
Advertisement
Table of Contents
