Troubleshooting Guide - Hunter SRC Plus Product Information Manual

TROUBLESHOOTING GUIDE

PROBLEM
Transmitter display is blank.
Can't access all the desired station on the
Transmitter.
Receiver doesn't beep two times after
plugging it in.
Receiver beeps twice after plugging it in,
but won't respond to Transmitter.
Transmitter display stays on.
"ERR" message in controller display when
controller is in the radio run position.
Receiver does not receive signal from
remote held at close range.
Remote has short range (i.e. less range
than 100 feet).
30
CAUSES
Transmitter is off.
Maximum station number is set wrong.
SmartPort is not connected properly.
®
Controller has no power.
Receiver and Transmitter address don't
match.
Transmitter will turn off automatically.
SmartPort wiring leads have been
®
extended and are receiving radio
interference.
Mismatch of addresses in transmitter and
receiver.
Check for interference causes.
SOLUTIONS
Press any button for 1 second.
See "Changing the Maximum Number".
Recheck SmartPort wiring.
®
Check controller power.
Relearn address at receiver.
Wait approximately 5 minutes without
pressing any buttons. Transmitter will "fall
asleep."
Replace lengthened wire with shielded
cable to prohibit interference. Use Hunter
SRR-SCWH.
Reset address of receiver.
See "Maximizing Operating Range" and "A
Word About Range" on page 29.