Hunter SRC Plus Product Information Manual page 20

PROGRAMMING
Manually Run a Single Station
1. Turn dial to the
MANUAL-
SINGLE
STATION
position.
2. Station run time will flash in the
display. Use the button to move to
the next station. You may use the
button to select the amount of time
for a station to water.
3. Turn the dial clockwise to the RUN
position to run the station (only the
designated station will water, then the
controller will return to automatic mode
with no change in the previously
set program).
Manually Run All Stations
1. Turn dial to
MANUAL-ALL
STATIONS.
2. You can select
program A, B, or C by pressing the
button.
3. Press the button until desired starting
station is displayed.
4. Station run time will flash in the
display. Use the or
select the amount of run time for the
station to water.
5. Use the button to move to the
next station.
6. Repeat steps 3 and 4 to customize
each station.
7. Press the button until you reach the
station that you would like watering
to begin.
8. Return dial to RUN (custom program
will water, then controller will return to
automatic mode with no change in the
previously set program).
18
(continued)
or
One Touch Manual Start and Advance
You can also activate all stations to water
without using the dial.
1. Hold down the
2. This feature automatically defaults to
3. The station number will be flashing.
buttons to
4. Press the
This feature is great for a quick cycle when
extra watering is needed or if you would like
to scroll through the stations to inspect your
system.
NOTE: The station that is
on the display when you
turn the dial to RUN will be
the first station to run. The
controller will then proceed
to water in sequential order
only. It will not water previous
stations. Example: If you
turn the dial to RUN with the
display reading station 3. The
controller will water stations
3 to 9 in the program, but not
return to stations 1 and 2.
button for 2 seconds.
program A. You can select program B
or C by pressing the program.
Press the button to scroll through
the stations and use the
to adjust the station run times. (If no
buttons are pressed during step 2 or 3,
the controller will automatically begin
program A.)
button to scroll to the
station you wish to begin with. After a
2 second pause, the program will begin.
or buttons