Hunter SRC Plus Product Information Manual page 29

Changing the Receiver Address
1. Hold down the single button on the
face of your Receiver while you are
plugging it into an active wiring
harness (one connected to a powered
controller). When this is done, the
Receiver will beep 4 times.
2. After the Receiver starts to beep,
release the button.
3. Press either the "ON" or "OFF" button
of your Transmitter.
4. The Receiver will beep 4 additional
times indicating that it has learned
the new Transmitter address and will
respond only to it from this point on.
NOTE: The SRR remote
receiver should not be
permanently installed in
an outdoor or unsheltered
location.
Run Time
You have the ability to adjust the amount
of time that a station will run once it has
been turned on by your SRR System.
This does not affect the run time
programmed into your controller. This
adjustment is made at the transmitter as
described below.
To change the Run Time follow the
steps below:
1. If the unit is OFF (no display), power
the transmitter up by pressing any of
the buttons for at least 1 second then
releasing the button. The transmitter
will first illuminate the entire display
for 1 second then display the
active station.
SRR Remote Control
2. Simultaneously press the
buttons, until the word "RUN TIME"
along with the current Run Time is
displayed (default is 10 minutes). The
display will be blinking at this point.
If more than 5 seconds go by without
a button being pressed, the Transmitter
will revert back to displaying the
active station.
3. Use the or buttons to change the
Run Time to any of 8 settings ranging
from 1 to 30 minutes. Then do not
touch any of the buttons for 5 seconds
and the display will stop blinking, and
return back to the active station.
Activating a Station with the SRR
Remote Control System
The SRR System will allow you to
remotely turn on and off any station on
your SRC Plus , Pro-C, and ICC with the
press of a button. Once on, the station
will run for the run time you have
designated in the remote.
To remotely activate a station or
program follow the steps below:
1. Plug the
Receiver into
an active
wiring harness
(one attached
to a powered
controller)
and wait for 2 beeps indicating that the
Receiver is ready.
2. If your Transmitter is not on (no
display), press any button for at least
1 second and release. The Transmitter
will first illuminate the entire display,
then display the active station.
and
27