Hunter SRC Plus Product Information Manual page 18

PROGRAMMING
Setting Watering Start Times
1. Turn the dial to the
SET WATERING
START TIMES
position.
2. The factory preset
is set on program
A. If necessary,
you can select
program B or C by pressing the
button.
3. Use the or button to change the
start time. (The start times advance
in 15 minute increments.) Hold either
button down for 1 second to change
times rapidly.
4. Press the button to select the
next start time, or press
next program.
NOTE: One start time
will activate all stations
sequentially in that program.
This eliminates the need
to enter each stationʼs start
time. Multiple start times in
a program can be used for
separate morning, afternoon,
or evening watering cycles.
Eliminating a Program Start Time
With the dial set to the SET WATERING
START TIMES position, push the
or button until you reach 12:00
(Midnight). From here push the
once to reach the OFF position.
16
(continued)
�
�
�
�
�
�
�
Setting Station Run Times
(Length of Watering for Each Area)
1. Turn the dial to the SET STATION
2. The display will show the last program
for the
3. Use the
4. Press the
5. Repeat steps 3 and 4 for each station.
6. You can set station run times anywhere
7. You can move between programs while
AM
button
NOTE: If a program has all
four-start times turned off,
then that program is off. (All
other program details are
retained). Because there are
no start times, there will be no
watering with that program.
This is a convenient way to
stop watering on one program
only without turning the dial to
the OFF position.
RUN TIMES position.
selected (A, B, or C) the station number
selected, and the run time for that
station will be flashing. You can switch
to another program by pressing the
button.
or button to change the
station run time on the display.
button to advance to the
next station.
from 0 to 99 minutes.
staying on the same station. However,
it is recommended that one program is
completed before going on to the
next program.
NOTE: Jumping between
programs can be confusing
and may result in program
entry errors.
�
�
�
�
�
�
�