Hunter SRC Plus Product Information Manual page 30

INSTALLATION AND PROGRAMMING
3. Use the
or buttons
to display
the station or
program you
would like
to start.
4. Momentarily
press the "ON"
button to start
the station or
program. The Transmitter will display
the word "TRANSMIT" and will flash
for about 4 seconds indicating that it is
sending the command to the Receiver.
If you are near the Receiver, you will
hear it beep 2 times, indicating that it
has received the command.
5. Press the "OFF" button to turn off any
station that is on. The display will again
read "TRANSMIT" and flash, and the
Receiver will again beep twice. The
SRR System is designed to turn one
station on at a time. Therefore, turning
a station on while another station is
already on will cause the first station to
turn off.
Note: The SRR remote
can activate any station
on the controller whether
the controller dial is in the
"System Off," "Run" or "Run/
Bypass Sensor" modes.
If a sensor device has
been wired to the controller,
the SRR remote will not
override the sensor for manual
operation unless the controller
dial is in the "Run/Bypass
Sensor" position.
28
(continued)
Changing the Maximum Station Number
Your SRR Transmitter comes from the
factory with the maximum station number
set to 9. This means that when you use the
and buttons to change the station, you
may change it to any number between
1 and 9. However, if you only have a
6-station controller, you will never need
to access stations 7-9. Likewise, perhaps
you will own a future Hunter controller
with more than 9 stations. In this case you
would want to access the stations above 9.
The SRR Transmitter allows you to set the
maximum station number as follows:
1. If the unit is OFF (no
display), power the
Transmitter up by pressing
any of the buttons for at least
1 second then releasing the
button. The Transmitter will
first illuminate the entire
display for 1 second then
display the active station.
2. Simultaneously press the
and buttons, until the
word "RUN TIME" along
with the current Run Time is
displayed. The display will
be blinking at this point.
3. While the display is blinking
and showing the current
address, press the "ON"
button. The display will
continue to blink, but the
word "ADDRESS" will be illuminated.
4. Press the "ON" button again. The
display will continue to blink, but the
word "ADDRESS" will no longer
be illuminated.
�������
�������
��