Hunter SRC Plus Product Information Manual page 5

Large LCD display...
Easy to read
The large LCD display simplifies pro-
gramming by making the controller entries
easy to read and verify. Symbols and
numbers on the display make it easy to
understand in any language.
Remote Ready...
Provide your controller with simple
and reliable operation away from its
mounting location
The SRC Plus is remote ready! A
SmartPort wire harness is supplied
®
with the SRC controller to permit the
attachment of a Hunter SRR remote
receiver. The easy-to-install handy option
can help save time and effort by allowing
remote valve operation away from the
controller.
One Touch Start and Rapid
Manual Advance...
Activate stations to water without using
the dial
A special feature that Hunter has
incorporated into the SRC is called the
One Touch Start and Manual Advance.
SRC Plus Controller
It has increased the user-friendliness of
the controller with fewer steps to activate
stations without the use of the dial. This
feature is great for a quick start of a cycle
when extra watering is needed or if you
would like to scroll through the stations in
sequential order to inspect the irrigation
system.
Procedure to operate the Manual Start
Feature for an extra watering cycle
1. Press the button for 2 seconds.
2. Station run time will flash in the
display. This feature automatically
defaults to program A. You can select
program B or C by immediately
pressing the button before the
PRG
number stops flashing. To operate the
entire program as scheduled, no other
handling is required. After a 2 second
pause, the program will begin.
3. If a particular station needs a onetime
adjustment to its run time for this
cycle then press the button (while the
run time is flashing) to scroll through
the stations until the desired station
number appears. Use the
button to adjust the station run time.
The controller will begin to operate
that station within 2 seconds. (If no
buttons are pressed during step 2 or 3,
the controller will automatically begin
program A.) After the selected station
has completed its altered run time the
controller will then proceed to water
subsequent stations, with their original
programming, in sequential order only.
It will not water previous stations.
or
3