Remote Connection - Bosch Rexroth IndraMotion MLC Operating Instructions Manual

IndraControl VPB 40.4
NOTICE
Do not interrupt the firmware download and the installation.
After the download, close the dialog with Close. The system firmware is
started.
4. Restarting the control
After the firmware has been downloaded successfully, the control is
automatically restarted.
Under certain circumstances, an FPGA update on the hardware is
additionally required. In this case, the following message (PWRCYCLE) is
displayed after the firmware download:
Fig. 12-26: Firmware download: Message "PWRCYCLE"
In this case, shut down the industrial PC. Separate the power supply from
the UPS for a short period and wait until the UPS is switched off. Then,
restart your system.
The control is then ready.

12.11 Remote connection

If the IndraMotion MLC VPB40.4 control is used without an own display within
the system environment, setting up the remote desktop for Windows is
reasonable. The control can be directly operated and diagnosed from your
DOK-MLC***-INDRACTRLV4-IT02-EN-P
Damage to the device due to canceled
firmware download
Bosch Rexroth AG
Device description
73/87