Closing 2-Stroke Oil Tank Cap; Cold Start Button; Idle Speed Adjusting Screw - Husqvarna TX 300i 2022 Owner's Manual

6.11

Closing 2-stroke oil tank cap

6.12

Cold start button

6.13

Idle speed adjusting screw

–
Put the 2-stroke oil tank cap on and turn it clockwise.
–
1
Fold loop
The 2-stroke oil tank cap engages.
K01333-10
The cold start button
body.
If the engine is cold and the ambient temperature is low, the
electronic fuel injection system extends the injection time. To
help the engine burn the increased fuel quantity, it must be sup-
plied with additional oxygen by pulling the cold start button.
Info
If the engine is warm, the cold start button must be deac-
K01324-11
tivated.
Possible states
The cold start button is activated – The cold start button is
•
pulled out all the way and turned by a ¼ turn.
The cold start button is deactivated – A further ¼ turn
•
returns the cold start button back to the basic position.
The idle setting of the throttle valve body substantially influences
the vehicle's starting behavior, a stable idle speed, and the vehi-
cle's response when the throttle is opened.
An engine with a correctly set idle speed is easier to start than an
engine with the idle speed set incorrectly.
The idle speed is adjusted using the idle speed adjusting
1
screw .
Info
If the idle speed is high, the engine is slow to run, the
K01324-10
engine brake is low and the throttle response is aggres-
sive, the adjustment screw must be turned clockwise.
If the idle speed is low, the engine is running fast,
the engine brake is high and the throttle response
is not clean, the adjusting screw must be turned
counterclockwise.
down.
1
is fitted on the side of the throttle valve
CONTROLS 6
19