16 TUNING THE ENGINE
16.4
112
V02151-10
Adjusting the idle speed
Warning
Danger of accidents The engine may go out spontaneously if the idle speed is set too low.
–
Set the idle speed to the specified value. (Your authorized Husqvarna Motorcycles workshop will be
glad to help.)
K01324-10
–
Clean the outside of the handlebar and the inside of the grip
tube. Mount the grip tube on the handlebar.
–
Attach the throttle cables to the guide plate and route cor-
rectly.
–
3
Position half-shells
, mount and tighten screws
Guideline
Screw, throttle grip
–
1
Slide on sleeve
and check the throttle grip for ease of
movement.
Finishing work
–
Check the play in the throttle cable. (
–
Run the engine until warm.
The cold start button is deactivated – A further ¼ turn
returns the cold start button back to the basic position.
(
p. 19)
Danger
Danger of poisoning Exhaust gases are toxic and
inhaling them may result in unconsciousness and
death.
–
Always make sure there is sufficient ventilation
when running the engine.
–
Use effective exhaust extraction when starting or
running the engine in an enclosed space.
–
Adjust the idle speed by turning idle speed adjusting
1
screw
.
Guideline
Idle speed
Tachometer (45129075000)
2
M6
5 Nm (3.7 lbf ft)
p. 110)
1,400 ... 1,500 rpm
.