Adjusting Spray Jets; Removing And Installing Washer Fluid Reservoir - Audi A3 1997 Service

Audi A3 1997 ➤
Electrical system - Edition 10.2003
- -> Detach fluid hose -4- at spray jet -3-.
- Screw out bolts -1- and -2- and detach spray jet.
Installing
Install in reverse order, paying attention to the following:
Note:
Secure all hose connections with standard hose clamps.
=> Parts List
- Use pliers V.A.G 1275 to fit hose clamp.
- Install front bumper.
=> General Body Repairs, Exterior; Repair Group 63
Tightening torque
Component
Spray jet to bumper

4.3 - Adjusting spray jets

Note:
The spray jets supplied are pre-set at the factory and do not have to be adjusted following installation.

4.4 - Removing and installing washer fluid reservoir

Note:
The joint washer fluid reservoir for the windscreen and headlight washer systems is located at the front left of
the engine compartment. Removing and installing => Page
88
92 - Windscreen wipe and wash system
Nm
2.5
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
74 .