Audi A3 1997 Service page 39

Removing
- -> Remove lower air pipe -arrows-.
- -> Remove centre and right noise insulation -arrows-.
Note:
Before removing, mark direction of ribbed belt with chalk or felt-tipped pen. Running a used belt in the opposite
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
direction could destroy it.
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
- Apply flat 16 mm box wrench at hexagon of tensioning roller.
- -> Swivel tensioning roller in direction of arrow to slacken off ribbed belt.
- Detach ribbed belt.
Audi A3 1997 ➤
Electrical system - Edition 10.2003
2.5 - 1.9l TDI engine - distributor-type injection pump
31