Table of Contents
Advertisement
Complete prerequisite checklist for Windows XP: Remote console through dial-up support: Complete
the following checklist to set up a remote console through dial-up on Windows XP:
__ 1. Meet Operations Console hardware requirements.
__ 2. Meet Operations Console software requirements.
__ 3. Run prerequisite checking program on the PC.
__ 4. Install iSeries Access for Windows.
__ 5. Apply iSeries Access for Windows service packs.
__ 6. Install PC modem.
__ 7. Configure Operations Console on the PC.
Complete required prerequisite tasks
Complete each prerequisite task needed for your configuration and operating system. This is a reference
section that lists all of the required tasks that you should complete before configuring Operations
Console. Use your checklist that you created that lists the specific tasks that you need to complete. Your
checklist lists only the tasks that you need based on your operating system and configuration type. If you
have not created a checklist yet, see Set up Operations Console.
Here is the list of all possible tasks:
Meet Operations Console hardware requirements
Meet Operations Console hardware requirements for the PC and iSeries.
Meet Operations Console software requirements
Meet Operations Console software requirements for the PC and iSeries.
Meet Operations Console cable requirements
Meet Operations Console cable requirements for the PC and iSeries.
Verify available communications port
Verify that you have an available communications port for your Operations Console configuration.
Run prerequisite checking program
Run the prerequisite checking program prior to beginning your Operations Console configuration.
Install iSeries Access for Windows
Install iSeries Access for Windows to load Operations Console on your PC.
Apply iSeries Access for Windows service packs
Apply iSeries Access for Windows service packs to receive the latest level of iSeries Access for
Windows.
Install AS/400 Operations Console Connection Modem
Install the Operations Console Connection modem that is shipped with Operations Console in order
for a local console to communicate with the server using the Operations Console cable. Only use
these instructions if you are configuring a local console directly attached to the server or a local
console directly attached to the server with remote access allowed.
Install PC modem
Install the PC Modem to allow your local console to communicate with one another using a
telephone connection.
Confirm installation of TCP/IP on the PC
Confirm installation of TCP/IP on the PC to satisfy the network requirements for Windows NT
33
Operations Console
Advertisement
Table of Contents
