Table of Contents
Advertisement
Install Remote Access Service
Install Remote Access Service if you are using Windows NT.
Install Microsoft service pack
Install Microsoft Service Pack after you install Remote Access Service.
Grant remote access
Grant remote access if you are using Windows NT, Windows 2000, or Windows XP.
Create and configure incoming connections
Create and configure incoming connections if you are using Windows 2000 or Windows XP.
Install Operations Console cables
Install Operations Console cables to allow your directly attached console to connect to the server.
Configure Operations Console on the PC
Configure Operations Console on the PC when you have completed all of the prerequisites.
Instructions to begin the Operations Console configuration wizard are included.
Run prerequisite checking program
You should run the prerequisite checking program prior to beginning your Operations Console
configuration. Run this tool on every PC for which you want an Operations Console connection. It will
check for some of the prerequisites and then tell you how to address any missing components.
Start the prerequisite checking program.
Install iSeries Access for Windows
Before you use Operations Console, you must install iSeries Access for Windows. During the installation
of iSeries Access for Windows, you are going to install a 5250 emulator (if you do not already have
PC5250 or IBM Personal Communications V5.7 CSD 1 minimum) and Operations Console support. See
the iSeries Access web site for updated PC requirements.
To check whether you have iSeries Access for Windows installed:
1. Click Start and select Settings.
2. Click Control Panel.
3. Double-click Add/Remove Programs.
4. Look for IBM iSeries Access for Windows.
5. To close Add/Remove Programs, click Cancel.
6. Close the Control Panel.
If you do not have iSeries Access for Windows installed, use the iSeries Setup and Operations CD-ROM to
install it:
1. Insert the iSeries Setup and Operations CD-ROM in the CD-ROM drive.
2. Select the iSeries Access for Windows option to start the installation.
3. Wait until the IBM iSeries Access for Windows window appears.
4. To continue with the setup program, click Next and follow the prompts.
Refer to iSeries Access for Windows for further installation assistance.
5. If you are installing iSeries Access for Windows for the first time, you have to ensure that you have at
least a minimum configuration for running Operations Console. If you are only adding the Operations
Console component, add only the components necessary to meet this minimum configuration.
6. To ensure the minimum configuration, select Custom or Full install and select at least the following
components:
34
iSeries: iSeries Access for Windows Operations Console
Advertisement
Table of Contents
