Table of Contents
Advertisement
a network configuration. Once the LAN card is deactivated you can move it or use it for another
purpose. You must also be using a console type other than an Operations Console local console on a
network (LAN) or the steps below will cause the console to disconnect. Follow these steps to deactivate
the LAN adapter currently associated with an Operations Console local console on a network (LAN):
Note: To perform the following procedure using SST, select the option Work with service tools user IDs
and Devices everywhere it says select Work with DST environment.
1. Access Dedicated Service Tools (DST) or System Service Tools (SST).
2. Select Work with DST environment.
3. Select System devices (skip this step if using SST).
4. Select Console.
5. Select Operations Console (LAN). The LAN adapter currently in use should be shown.
6. Press F11.
7. Press F6 to perform a clear.
8. Press F7 to store the new values.
9. If you are not using this resource for the console, press F13 to deactivate the adapter. You will be
required to use another console type or resource on the next IPL.
Note: After you exit this window, do not enter the configuration again. Entering the configuration
again may reallocate the LAN adapter resource to Operations Console.
10. Press F12 twice to exit this window.
You should have returned to the Work with System Devices window. If you are using SST, this
returns you to Work With Service Tools User IDs and Devices.
11. Select Console.
12. Select the console type you want to use.
Important: You must change the console type to something other than Operations Console (LAN) or the
adapter will get reallocated on the next IPL.
Changing network values for Operations Console (LAN)
|
|
If you need to make a change to the network adapter used for Operations Console (LAN), such as a new
|
IP address use these instructions:
|
Note: To perform the following procedure using SST, select the option Work with service tools user IDs
and Devices everywhere it says select Work with DST environment.
|
1. Access Dedicated Service Tools (DST) or System Service Tools (SST).
|
2. Select Work with DST environment.
|
3. Select System Devices (skip this step if using SST).
|
|
4. Select Console.
|
5. Select Operations Console (LAN). The LAN adapter currently in use should be shown.
6. Press F11.
|
7. Use one of the following methods to make your change:
|
v If you are making a simple change, such as the IP address, enter in the new values and continue
|
|
with step 8.
v If you will be changing the adapter card press F6 to perform a clear. Continue with step 8.
|
8. Press F7 to store the new values.
|
9. Press F3 until the DST main menu appears.
|
|
Important: If the change did not affect the network IP address or the service host name (interface
|
name) you can exit these instructions now.
84
iSeries: iSeries Access for Windows Operations Console
Advertisement
Table of Contents
