ASUSTeK COMPUTER GigaX3112 Series User Manual page 67

GigaX3112 Series Layer 3 Managed Switch
Authentication Control: If "ForceAuthorized" is selected, the selected
port is forced authorized. Thus, traffic from all hosts is allowed to pass.
Otherwise, if "ForceUnauthorized" is selected, the selected port is blocked
and no traffic can go through. If "Auto" is selected, the behavior of the
selected port is controlled by 802.1x protocol. All ports should be set to "Auto"
under normal conditions.
Reauthentication: Once enabled, the switch will try to authenticate the port
user again when the re-authentication time is up.
ReAuthentication Time: If "Reauthentication" is enabled, this is the time
period the switch uses to re-send authentication request to the port user (see
above).
Quiet Period: If authentication failed, the switch waits upon this time period
before sending another authentication request to the port user.
Retransmission Time: If the port user failed to respond to authentication
request from the switch, the switch waits upon this time period before
sending another authentication request to the port user.
Max Reauthent Attempt: Retry count if the port user failed to respond to
authentication requests from the switch.
Guest Vlan: Specify a guest VLAN to clients that are not 802.1x-capable.
Click OK to make the settings permanent. Click Reload to refresh the settings to
current value.
54