GigaX3112 Series Layer 3 Managed Switch
5.3.27.4 switchport port-security aging
This command used to set the port security aging configuration.
CLI Syntax: switchport port-security aging {time TIME | type {absolute |
inactivity}}
Example: (config)# interface gi1/0/1
5.4 Miscellaneous commands
show monitor: shows the environment variable, like temperature, fan speed
and voltage.
show sysleds: shows the three system LEDS – SYSTEM, RPS and FAN.
show modelname: shows the model name of switch.
show version: shows the hardware, boot rom and firmware version.
ping: ping remote host
show ip route: display the entries in the routing table
88
(config-if)# switchport port-security aging time 20
(config-if)# switchport port-security aging type absolute