Filter Attach - ASUSTeK COMPUTER GigaX3112 Series User Manual

GigaX3112 Series Layer 3 Managed Switch
Note

4.8.2 Filter attach

A filter set is idle if you did not attach it to any ingress port. Use the Filter Attach
page to attach a filter set to ingress ports.
Click OK to save the configuration. To make the configuration effective, go to
the "Save Configuration" page, then click Save, or click on Reload to refresh the
page.
To attach a filter set to ports:
Attach to all ports: the filter set applies to all the ports of the system.
Attach to certain ports: you can specify the ingress ports to be applied.
Detach from all ports: remove all the filters from the attached ports.
Note
52
Figure 58. Filter rule in IP mode
Two examples tell us about the how of IP provisioning:
1. Assign a dedicated IP
Type = subnet IP = 10.10.1.2 Wildcard = 0.0.0.0
2. Assign a subnet (a group of IP)
Type = subnet IP = 10.10.1.0 Wildcard = 0.0.0.255
You may not detach certain ports after issuing an "Attach All"
command. If you wish to detach ports, use the "Detach All"
command.