Traffic Control; Dynamic Addresses - ASUSTeK COMPUTER GigaX3112 Series User Manual

GigaX3112 Series Layer 3 Managed Switch
4.5.7 Traffic control
Traffic control prevents the switch bandwidth from flooding packets including
broadcast packets, multicast packets and the unicast packets because of
destination address lookup failure. The limit number is a threshold to limit
the total number of the checked type packets. For example, if broadcast and
multicast are enabled, the total traffic amount for those two types will not exceed
the limit value.
Selects an interface and assigns desirable settings, then click Modify.
Click OK to make the setting send to the switch (HTTP server). Click Reload to
refresh the settings to current value.
Figure 29. Traffic control

4.5.8 Dynamic addresses

This page displays the result of dynamic MAC address lookup by port, VLAN ID,
or specified MAC address. The dynamic address is the MAC address learned by
switch, it will age out from the address table if the address is not learned again
during the age time. User can set the age time by entering a valid number from
10 to 1,000,000 in seconds. Then click on OK to save the new age value.
To make the configuration effective, please go to "Save Configuration" page,
then click on Reload.
You can look up MAC addresses by checking the port, VLAN ID, or/and MAC
address, then click on the Query. The address window will display the result of
the query.
30