Area; Multicast Route; M-Route - ASUSTeK COMPUTER GigaX3112 Series User Manual

GigaX3112 Series Layer 3 Managed Switch
4.6.4.3

Area

This function is used to configure OSPF areas
Select a Area: Input area ID to be configured
Default Cost: Default cost for a stub area sending packet to outside world
Stub: Used to specify characteristics of this area(normal, stub no summary
and stub summary)
Range: Used to specify a set of network which belong to this OSPF area
Virtual Link: Used to specify a virtual link configuration, the other end
router-id of virtual link you want to establish is input on this field

4.6.5 Multicast Route

This function is used to configure Multicast Route feature. It offers two different
methods including DVMRP and PIM-DM to establish multicast route. And, IGMP
will be automatically enabled/disabled with Multicast Route Protocol. It allows
hosts to communicate with their interest and desire data destined to a specific
multicast group. Multicast route protocol uses this information to build and
maintain multicast distributed tree.
4.6.5.1

M-Route

This command is used to configure IP multicast route mode and IGMP parameters.
IP Multicast Route Mode: Configure a multicast route protocol to run or disable.
IGMP Version: Select which version IGMP run. Default value is V2.
IGMP Query Interval: Set the number of seconds between two query
packets. Default value is 125 sec.
IGMP Query-Max-Response: Set response time when host reports its
multicast group. Default value is 10 sec.
42
Figure 45 OSPF Advanced Configuration 2