Pnp/Pci Configuration Setup - QDI P6I440EX/MATX EXCELLENT II Manual

Table of Contents

Advertisement

AWARD BIOS Description
• Standby
Mode
• Suspend
Mode
• HDD Power
Down
• Throttle Duty
Cycle
• VGA Active
Monitor
• Soft-off by
PWR-BTTN
• Resume by
Ring/LAN
• Resume by Alarm
• IRQ 8 Break
Suspend
• IRQ [3-7, 9-15],
NMI

PNP/PCI Configuration Setup

PNP OS Installed
Resources Controlled By
3 - 10
1Min ∼ 1 Hr
Defines the continuous idle time before the system
enters the Doze mode. If any item defined in "Wake
Up Events In Doze & Suspend" is On and activated,
the system will be waken up.
Disabled
The system will never enter Standby mode.
1 Min ∼ 1Hr
Defines the continuous idle time before the system
enters the Standby
"Wake Up Events In Doze & Suspend" is On and
activated, the system will be waken up.
The system will never enter Suspend mode.
Disabled
1 Min ∼ 1Hr
Defines the continuous idle time before the system
enters the Suspend
"Wake Up Events In Suspend" is On and activated,
the system will be waken up.
HDD's motor will not be off.
Disabled
1 ∼15 Min
Defines the continuous HDD idle time before the
HDD enters the power saving mode (motor off).
Selects the duty cycle of the STPCLK# signal when
12.5%, 25%,
the system is in the system throttling mode.
37.5%, 50%,
62.5%, 75%,
87.5%
VGA active reloads global timer.
Enabled
VGA active has no influence to global timer.
Disabled
The system will power off immediately once the
Instant -off
power button is pressed.
Delay 4 Sec.
The system will not power off until the power button
is pressed continuously for more than 4 seconds.
Enabled
Allows the system to be powered on when a Ring
Indicator signal comes up to UART1 or UART2 from
external modem or comes up to the WOM header from
an internal modem card, or when a remote wake-up
signal comes up to the WOL header through the LAN
adapter.
Does not allow Ring Power-On and wake-up on LAN.
Disabled
Enabled
RTC alarm can be used to generate a wake event to
power up the system.
RTC has no alarm function.
Disabled
Enabled
Generates a clock event.
Does not generate a clock event.
Disabled
Note: IRQ8 Clock Event must be enabled when
using Resume By Ring and Alarm.
Enabled
Reload global timer.
Does not influence the global timer.
Disabled
ROM PCI/ISA BIOS (2A69JQ1K)
PNP/PCI CONFIGURATION
AWARD SOFTWARE, INC.
: No
: Manual
mode. If any item defined in
mode. If any item defined in
PCI IDE IRQ Map To
: ISA

Advertisement

Table of Contents
loading

Table of Contents