Assembly - KNOVA KN CS-3555R Manual

ASSEMBLY

WARNING
Never connect the plug to the power
source outlet until all installations and adjustments
are completed and you have read and understood
the safety and operational instructions.
WARNING
Failure to unplug your saw could result in
accidental starting causing possible serious personal
injury.
RAISING AND LOCKING THE CUTTING HEAD (FIG. A)
1. For shipping purposes, the cutting head is locked in the
down position.
2. Push down on the upper arm assembly and remove the
locking chain (1) from the hook (2).
NOTE: This chain is held in place by a tie down cord for
shipping purposes. Carefully cut this cord with a box
cutter or scissors.
3. After releasing the locking chain (1), move the cutting
head to the upward position. Do not remove the chain,
as you will need it for locking the arm down for storage.
STORING THE WRENCH (FIG. B)
When you are not using the cutting wheel wrench (1)
provided, a storage holder (2) is located on the rear
of the saw base.
Fig. B
2
1
Fig. A
2 1
INSTALLING AND CHANGING THE ABRASIVE CUTTING
WHEEL (FIG. C, D, E)
NOTE: Use only recommended reinforced
abrasive wheels (rated 3,600 RPM or greater).
1. Raise the cutting handle to the upward position.
2. Raise the cutting wheel guard (1) to the uppermost
position. (Fig. C)
3. Place the cutting wheel wrench (2) on the arbor
bolt (3). (Fig. D)
4. Push and hold in place the spindle lock (4) and then
loosen the arbor bolt (3) counterclockwise with
the cutting wheel wrench (2) provided. (Fig. D, E)
5. Remove arbor bolt (3), outer wheel flange (6)
and the abrasive cutting wheel (5). (Fig. E)
6. Install the new abrasive cutting wheel followed by
the outer wheel flange (6) and then the arbor
bolt (3). (Fig. E)
NOTE: Make sure the directional arrow on the
replacement wheel matches the direction of the saw.
7. Press the spindle lock (4). (Fig. E)
8. Turn the arbor bolt (3) clockwise until snug and tighten
with the cutting wheel wrench (2) provided. (Fig. D)
9. Make sure the wheel is secure.
10. Be sure the spindle lock (4) is released so the abrasive
cutting wheel (5) turns freely by spinning the cutting
wheel until the spindle lock (4) disengages.
11. Release the cutting wheel guard (1) back to its original
position. (Fig. C)
1
2
8
Fig. C
3
Fig. D