Fitting The Ventilation Hose Bracket; Mattress; Bed Canopy - Dräger Medical Babytherm 8000 WB Instructions For Use Manual

Warming bed
Table of Contents

Advertisement

Fitting the ventilation hose bracket

Insert the hose bracket into the hole in the left-hand end
panel and tighten with knurled nut.

Mattress

— When operating with mattress heater,
the gel mattress (2M 20 827) should be used.
Place gel mattress in the cot and cover it with a cotton
sheet.
Prevent contact with sharp objects as these could damage
the gel mattress.
Do not fold or kink the gel mattress. To transport the gel
mattress, roll it up.
Always observe the gel mattress warming-up time.
Wait for about 1 hour to allow the gel mattress to warm up
before placing a patient in the Babytherm.

Bed canopy

Optional
Higher side panels (230 mm) are recommended when using
the bed canopy.
Check that the bed canopy is closed.
When the bed canopy is not required:
Attach bracket to standard rail.
1 Hang bed canopy from bracket.
1
Preparation
11

Advertisement

Table of Contents
loading

Table of Contents