Download Print this page

PROAIM P-18-JS Assembly Manual page 3

18ft camera crane jib with stand for gimbals pan-tilt & fluid head

Advertisement

Continue the Arm build by sliding in section 3
onto section 4 as shown in the image.
Loosen the bolt from the connecting bar with
the help of a 6mm Allen key and wrench, and
then insert the bolt using the holes provided.
Then tighten them together using provided
allen key.
Continue the Arm build by sliding in section 2
onto section 3, and finally section 1 onto sec-
tion 2.
Then tighten them together using provided
allen key. As shown in the image.
Connect the Wire/Cable Tensioner with
cable. Simply rotate the mid-section handle
to tighten the cable adding required amount
of strength to the system.
3
Connecting Bar
Tighten Bolt

Advertisement

loading