NL
Malfunctions and how to fix them
Information on the display
Display
O
• ©£ (hot)
|
wlights up
The symbolkcut- Run the program Cotton 90°C off to clean the drum and outer tub
pert
E:36
alternates with
- 10
E:35
alternates with
- 10 (suitable for
special models)
50
Cause/Solution
Flashes quickly + signal: the door was opened and the water level is too
■
high. Close the door, resume the program with the buttonIStart/Reload or
choose pump down. Flashes slowly:the door lock temperature is too high
to open the door. Wait approx. 30 seconds for the door lock temperature to
■
drop.
The temperature in the drum is too high. Wait until the rotating appliance has
cooled down the laundry and the message•©£ (hot) on the display panel has
disappeared. After this, the door can be opened.
Flashing (no water supply): water tap turned on? Is the filter in the
■
water supply clogged?~ " The filter in the water supply is clogged" on
page 48
Is the supply hose kinked or pinched?
lights up (low water pressure): is for information only. The
■
program progress is not affected by this. The program duration is
extended.
The child lock is activated – deactivate it.
and maintain.
Clues
Run the program without any laundry.
■
Use washing powder or detergent with bleach. To avoid foaming,
■
use only half the amount of detergent recommended by the
detergent manufacturer. Do not use detergent intended for
woollens or delicates.
Switch the drum care information signal on/off.~ page 44
■
The drain pipe or water drain hose is clogged. Clean the drain pipe and the water
■
drain hose.
The drain pipe or water drain hose is jammed or closed. Make sure that the
■
drain pipe and water drain hose are not kinked or pinched.
The drain pump is clogged.
■
~" The drain pump is clogged" on page 46
The drain hose at the siphon is clogged.
■
~" The drain hose at the siphon is clogged" on page 47
The water drain hose is connected too high. Install the water drain hose at
■
a maximum height of 1 meter.
~ page 17
There is water in the base, the appliance is leaking. Turn off the tap. Call customer
service.