Table of Contents
Advertisement
Display
H:95
alternates with
"Ÿš (End)
when the pro
gram is completed
H:32
alternates with
"Ÿš (End)
when the pro
gram is completed
Other Displays
Malfunctions and how to fix them.
Malfunctions
Water is leaking from the
appliance.
The door cannot be
opened.
The appliance does not fill
with water.
No detergent is
dosed.
Cause/Solution
No water detected in the drying phase can lead to poor drying results.
~" The filter in the water supply is clogged" on page 48
The load imbalance detection system interrupted the spin cycle because
the laundry was unevenly distributed. Distribute small and large items of
laundry evenly in the drum.
Turn the program selector to (From), wait five seconds and turn it
back on. When the display reappears, contact customer service.
Cause/Solution
Fix or replace the drain hose correctly.
■
Tighten the screw fitting on the supply hose.
■
~~~ (Rinse hold = no final drain) is activated (depending on the
■
module). Resume the program bySpin/Drain to choose and
pressIStart/Reload to push. The temperature in the drum is
too high to open the door. The safety function is activated.
■
Stop program? The water level in the drum is too high.
■
■
Can the door only be opened with the emergency release?
■
~" Emergency release" on page 49
The program does not
■
start? Is the tap turned on?
■
Could the filter in the water supply be clogged?
■
~" The filter in the water supply is clogged" on page 48
Note:
If an additional water filter is installed (depending on
the model), check it for contaminants and clean it if necessary
~separate installation and cleaning instructions for water filter.
Is the supply hose kinked or pinched?
■
Malfunctions and how to fix them
NL
51
Advertisement
Table of Contents
